This paper presents a new circuit scheme to control the current surge in the boosting phase of an radio frequency identification-nonvolative memory pump. By introducing a circuit block consisting of a current reference and a current mirror, the new circuit scheme can keep the period-average current of the pump constantly below the desired level, for example, 2.5μA. Therefore, it can prevent the rectified supply of the RFID tag IC from collapsing in the boosting phase of the pump. The presented scheme could effectively reduce the voltage drop on the rectified supply from more than 50% to even zero, but could cost less area. Moreover, an analytical expression to calculate the boosting time of a pump in the new scheme is developed.
参考文献
| [1] | Karthaus U,Fischer M.Fully integrated passive UHF RFID transponder IC with 16.7-μW minimum RF input power.IEEE J Solid-State Circuits,2003,38:1602 |
| [2] | Dickson J F.On-chip high-voltage generation in MNOS integrated circuits using an improved voltage multiplier technique.IEEE J Solid-State Circuits,1976,3:374 |
| [3] | Liu D S,Zou X C,Zhang F,et al.New design of EEPROM memory for RFID tag IC.IEEE Circuits and Devices Mag,2006,22:53 |
| [4] | Barnett R,Liu J.An EEPROM programming controller for passive UHF RFID transponders with gated clock regulation loop and current surge control.IEEE J Solid-State Circuits,2008,43:1808 |
| [5] | Pan F,Samaddar T.Charge pump circuit design.1st ed.New York:McGraw-Hill,2006:42 |
| [6] | Tanzawa T,Tanaka T.A dynamic analysis of the Dickson charge pump circuit.IEEE J Solid-State Circuits,1997,32:1231 |
上一张
下一张
上一张
下一张
计量
- 下载量()
- 访问量()
文章评分
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%