欢迎登录材料期刊网

材料期刊网

高级检索

以新型的纳米氢氧化镁粉体为分散相研究对象,通过扫描电子显微镜、透射电子显微镜、Payne效应等考察了其在丁腈橡胶、三元乙丙橡胶、丁苯橡胶、硅橡胶中的分散相态和网络结构.结果表明,基体的粘度和表面能对纳米粉体最终的分散状态和网络结构有至关重要的影响.基体的粘度和表面能越高(NBR、EPDM),纳米粉体分散越精细,越容易形成柔性的网络结构,高分子参与比重很大;而在很低粘度和表面能的基体中(硅橡胶),纳米粉体以孤立的大聚集体形式存在,在低填充量下,不能形成网络结构,但在高填充量时,反而由大聚集体直接连成刚性很高的网络结构,高分子参与网络结构形成的程度小.传统的模型不能全面地考虑各种主要因素对粉体聚集体所受外力的影响,本文中提出了一个修正的模型来引入表面能因素的影响.

参考文献

[1] 王立新,张楷亮,任丽,等. 聚合物/层状硅酸盐纳米复合材料的研究进展 [J]. 复合材料学报,2001,18(3):5-9.
[2] 郑亚萍,王波. TiO2/环氧树脂纳米复合材料的研究 [J]. 复合材料学报,2002,19(4):11-13.
[3] Coran A Y, Donnet J B. The dispersion of carbon black in rubber: Part Ⅰ. Rapid method for assessing quality of dispersion [J]. Rubber Chem Technol, 1992,65(5): 973-997.
[4] Coran A Y, Donnet J B. The dispersion of carbon black in rubber: Part Ⅱ. The kinetics of dispersion in natural rubber [J]. Rubber Chem Technol, 1992,65(5): 998-1015.
[5] Donnet J B. The dispersion of carbon black in rubber: Part Ⅲ. The effect of dispersion quality on the dynamic mechanical properties of filled natural rubber [J]. Rubber Chem Technol, 1992,65(5): 1016-1041.
[6] Coran A Y, Ingatz-Hoover F, Smakula P C, et al. The dispersion of carbon black in rubber: Part Ⅳ. The kinetics of carbon black in various polymer [J]. Rubber Chem Technol, 1994,67(2): 237-251.
[7] Nakajima N, Harrell E R. Contributions of elastomer behavior to mechanism of carbon black dispersion [J]. Rubber Chem Technol, 1984,57(1): 153-167.
[8] Karasek L, Sumita M. Review Characterization of dispersion state of filler and polymer-filler interactions in rubber-carbon-black composites [J]. J Mater Sci, 1996,31(2): 281-289.
[9] Payne A R, Whittaker R E. Low strain dynamic properties of filled rubber [J]. Rubber Chem Technol, 1994,44(3): 440-478.
[10] Wu G, Asai S, Sumita M. Estimation of flocculation structure in filled polymer composites by dynamic rheological measurements [J]. Colloid Polym Sci,2000,278(3): 220-228.
[11] Kluppel M, Schuster R H, Gert Heinrich. Structure and properties of reinforcing fractal filler networks in elastomers [J]. Rubber Chem Technol,1997,70(2): 243-255.
[12] Miyasaka K, Watanabe K,Jojima E, et al. Electrical conductivity of carbon-polymer composites as a function of carbon content [J]. J Mater Sci, 1982,17(6): 1610-1616.
[13] Manas-Zloczower I, Nir A, Tadmor Z. Dispersive mixing in internal mixers--a theoretical model based on agglomerate rupture [J]. Rubber Chem Technol, 1982,55(5): 1250-1285.
[14] Shiga S, Furuta M. Processability of EPR in an internal mixer (Ⅱ)--morphological changes of carbon black agglomerates during mixing [J]. Rubber Chem Technol, 1985,58(1): 1-20.
[15] Manas-Zloczower I, Feke D L. Observation of carbon black agglomerate dispersion in simple shear flows [J]. Polym Eng Sci, 1990,30(12): 701-706.
[16] Rwei S D, Manas-Zloczower I, Feke D L. Characterization of agglomerate dispersion by erosion in simple shear flows [J]. Polym Eng Sci, 1991,31(8): 558-562.
[17] Bolen W R, Colwell R E. Soc Plast Eng [J]. 1958, 14(8): 24.
上一张 下一张
上一张 下一张
计量
  • 下载量()
  • 访问量()
文章评分
  • 您的评分:
  • 1
    0%
  • 2
    0%
  • 3
    0%
  • 4
    0%
  • 5
    0%