分别采用电化学方法和化学气相沉积法对生产线锡槽和退火窑内的浮法玻璃两次镀膜,制备出具有阳光控制功能的双层彩色浮法玻璃,采用分光光度计、扫描电镜、能谱仪、透射电镜、原子力显微镜和二次离子质谱等方法分析了复合镀膜样品的形貌、结构,研究了不同深度的膜层成分和性能.结果表明,可见光透射比与硅烷浓度和电流强度之间有强烈依赖性;上层的硅膜表面均匀平整,表面粗糙度约9.66 nm,团粒尺寸约100 nm,其厚度约70～78 nm,且沿厚度方向呈梯度化氧化;底层膜中铜和铋的扩散深度约10μm.
参考文献
| [1] | R.J.McCurdy,Thin Solid Film,351,66(1999) |
| [2] | R.Gordon,Journal of Non-Crystalline Solids,218,81(1997) |
| [3] | WANG Jianxun,China Building Material Equipment,6,34(1996)(汪建勋,中国建材装备,6,34(1996)) |
| [4] | LU Zhangming,LIN Yunfei,DIAO Tiefu,Glass,5,1(1991)(陆章明,林云飞,刁铁夫,玻璃,5,1(1991)) |
| [5] | S.Bhaumik,S.Kundu,A.P.Sengupta,Materials Chemistry and Physics,72,16(2001) |
| [6] | A.Arnaud,Non-Cryst.Sol.,218,12(1997) |
| [7] | S.Dhabal,T.B.Ghosh,Applied Surface Science,211,13(2003) |
| [8] | G.Brauer,Surface Coatings Technology,112,358(1999) |
| [9] | S.P.Bugaev,N.S.Sochugov,Surface and Coatings Technology,131,474(2000) |
| [10] | HAN Gaorong,WANG Jianxun,DU Piyi,Materials Science and Engneering,4,1(1999)(韩高荣,汪建勋,杜丕一,材料科学与工程,4,1(1999)) |
| [11] | M.Geisler,Ch.Bratz,J.Bruch,A.Kastner,M.Kress,M.Ruske,T.Willms,A.Zmelty,Thin Solid Films,442,15(2003) |
| [12] | G.Brauer,Surface and Coatings Technology,112,358(1999) |
| [13] | E.Ando,J.Ebisawa,Y.Hayashi,A.Mitsui,S.Suzuki,J.Non-Crystalline Solids,178,238(1994) |
| [14] | Erich Dumout,Bernard Dugnoille,J.Non-Crystalline Solids,218,307(1997) |
| [15] | ZHANG Yujuan,WU Zhiguo,YAN Pengxun,Chinese Journal of Materials Research,18(3),279(2004)(张玉娟,吴志国,阎鹏勋,材料研究学报,18(3),279(2004)) |
上一张
下一张
上一张
下一张
计量
- 下载量()
- 访问量()
文章评分
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%