欢迎登录材料期刊网

材料期刊网

高级检索

通过引入225℃空气氧化处理,在较短周期内采用常压浸渍炭化工艺制备了中间相沥青基炭/炭复合材料.采用偏光显微镜、万能力学试验机及扫描电镜等检测手段研究了炭/炭复合材料微观组织和弯曲力学性能.研究结果表明,225℃空气氧化处理后,炭化收率显著提高,经过四次常压浸渍-炭化循环后炭/炭复合材料密度达到了1.73g/cm3,弯曲强度为152.39MPa,比未经过空气氧化处理的试样提高了62.87%.空气氧化处理制备的试样呈现典型的假塑性断裂特征,而未经空气氧化处理制备的试样主要从层间断裂,其弯曲强度较低.通过偏光显微分析,未经空气氧化处理的炭/炭复合材料组织大部分为小域组织,只有少量的镶嵌型组织和广域组织,而经过225℃空气氧化处理后的试样,以广域型组织为主,并在其间夹着流线型组织和小域组织.

参考文献

[1] 李贺军.炭/炭复合材料.新型炭材料.2001,16(2):79--80.
[2] 徐国忠,李贺军,白瑞成,等(XU Guo-Zhong,et al)新技术制备C/C复合材料及特性研究.无机材料学报(Journal of Inorganic Materials),2006,21(6):1385-1390.
[3] Mochida I,Korai Y,Ku C H,et al.Chemistry of synthesis,structure,preparation and application of aromatic-derived mesophase pitch.Carbon,2000,38(2):305-328.
[4] Fathollahi B,Chau P C,White J L.Injection and stabilization of mesophase pitch in the fabrication of carbon-carbon composites.Part Ⅰ.Injection process.Carbon,2005,43(1):125-133.
[5] Dumont M,Dourges M A,Bourrat X,et al.Carbonization behaviour of modified synthetic mesophase pitches.Carbon,2005,43(11):2277-2284.
[6] Fathollahi B,Chau P C,White J L.Injection and stabilization of mesophase pitch in the fabrication of carbon-carbon composites:Part Ⅱ.Stabilization process.Carbon,2005,43(1):135-141.
[7] Fathollahi B,Jones B,Chau P C,et al.Injection and stabilization of mesophaae pitch in the fabrication of carbon-carbon composites.Part Ⅲ:Mesophaae stabilization at low temperatures and elevated oxidation pressures.Carbon,2005,43(1):143-151.
[8] 刘皓,李克智,李贺军,等(LIU Hao,et al).具有中间相沥青过渡层的炭/炭复合材料的微观结构与力学性能.无机材料学报,(Journal of Inorganic Materials),2008,23(3):486-490.
[9] 李贺军.模压半炭化成型方法制备炭素材料.中国发明专利:200410025830.6.5,2004.01.16.
[10] Liedtke V,Hüttinger K J.Mesophaae pitches as matrix precursor of carbon fiber reinforced carbon:1.Mesophaae pitch preparation and characterization.Carbon,1996,34(9):1057-1066.
[11] Liedtke V,Hüttinger K J.Mesophaae pitches as matrix precursor of carbon fiber reinforced carbon:Ⅱ.Stabilization of mesophase pitch matrix by oxygen treatment.Carbon,1996,34(9):1067-1079.
[12] Liedtke V,Hüttinger K J.Mesophaae pitches as matrix precursor of carbon fiber reinforced carbon:Ⅲ.Mechanical properties of composites after carbonization and graphitization treatment.Carbon,1996,34(9):1081-1086.
[13] 孙乐民,李贺军,张守阳.沥青基炭/炭复合材料的弯曲断裂特征.新型炭材料,2001,16(3):28-31.
上一张 下一张
上一张 下一张
计量
  • 下载量()
  • 访问量()
文章评分
  • 您的评分:
  • 1
    0%
  • 2
    0%
  • 3
    0%
  • 4
    0%
  • 5
    0%