最终关键尺寸是评价薄膜晶体管液晶显示器产品性能的一项重要参数。本文研究了在光源照度变化的条件下得到准确的最终关键尺寸的方法。通过大量的实验测试、数据分析，并配合扫描电子显微镜(SEM)图片，确定最终关键尺寸合适的测试条件和方法。基于上述分析，选取测量值稳定的光照强度区间中心点的光照强度作为标准样品参照值，选取此时样品测试图片作为标准图片。测试结果与 SEM 结果进行对比，得到不同膜层测量值和真实值之间的补偿值。并通过不同尺寸产品的数据收集和分析来验证补偿值的可靠性。通过上述方法，可以极大地缩短最终关键尺寸测量的校正周期，并为今后新产品开发提供可靠的测试标准。
Final inspection critical dimension (FICD)is an important parameter to evaluate the per-formance of thin film transistor liquid crystal display (TFT-LCD)products.The method to obtain an accurate FICD data was studied in this paper.By a large number of experimental data and the scanning electron microscope (SEM)images,test conditions and methods were determined.Based on the above analysis,the center of illumination intensity which could provide stable measuring results was selected as the reference value,and the image was collected as golden sample simultaneously.By contrasting the above results and SEM results,the compensation value of the different layers between measured value and true value were obtained.Also the reliability was proved by data analysis of different sizes of products.As a result,calibration period of FICD measurement could be reduced greatly,and relia-ble test standard was provided for future products.
参考文献
| [1] | 杨晓萍.京东方 TFT-LGD 竞争策略研究[D].北京:对外经济贸易大学,2012. Yang X P.Competition strategy research on the TFT-LCD industry of BOE [D].Beijing:University of Interna-tional Business and Economics,2012.(in Chinese),2012. |
| [2] | 吴凌剑 .TFT-LCD面板行业竞争策略研究——以A公司为例[D].苏州大学,2013. |
| [3] | 李联益.TFT-LCD液晶显示技术与应用[J].韶关学院学报,2012(04):46-49. |
| [4] | 黎午升,惠官宝,崔承镇,史大为,郭建,孙双,薛建设.在镜像投影曝光机上使用相移掩膜提高解像力的初步研究[J].液晶与显示,2014(04):544-547. |
| [5] | 全眞永,姜昌憲,安星俊,田正牧,李貞烈.基于PenTile RGBWTM算法的高像素密度a-Si TFT移动液晶显示屏[J].液晶与显示,2006(05):474-477. |
| [6] | Leea J H,Kim Y S,Kim S R,et al.Real-time application of critical dimension measurement of TFT-LCD Pattern using a newly proposed 2D image-processing algorithm [J].Optics and Lasers in Engineering,2010,46:558-569.,2010. |
| [7] | Vassilios Co,Vijaya-Kumar M,Evangelos Go.Effects of image noise on contact edge roughnses and critical dimen-sion uniformity measurement in synthesized scanning electron microscope images [J].J ournal of micro/nanol-ithography,MEMS,and MOEMS:J M3,2013,12(1):5-13.,2013. |
| [8] | Vladimir U,Bill B.Review of reference metrology for nanotechnology:significance,challenges,and solutions [J]. J ournal of Micro/Nanolithography,MEMS,and MOEMS:J M3,2012,1 1(1):10-1 1.,2012. |
| [9] | Sung-Hoon P,Tai-Wook K,Jeong-Ho L,et al.Real-time critical dimension measurement of thin film transistor liquid crystal display patterns using optical coherence tomography [J].J ournal of Electronic Imaging,2014,23(1):1-13.,2014. |
- 下载量()
- 访问量()
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%