采用磨削-抛光加工、金刚石锯片切割加工、超声波加工和电火花线切割加工技术对Al2O3/TiC陶瓷材料进行加工.研究了各加工方法对陶瓷材料的加工表面完整性及其可靠性的影响.结果表明:加工方法对陶瓷材料加工表面完整性和可靠性有很大的影响.磨削-抛光加工的陶瓷试样表面粗糙度小,硬度高,抗弯强度及其可靠性最高.金刚石锯片切割加工和超声波加工次之;电火花加工陶瓷试样表面粗糙大,硬度低,抗弯强度及其可靠性最低.电火花加工陶瓷表面产生一硬度低且表面粗糙的约8μm厚的热影响层,加工表面含有大量的电火花腐蚀凹坑,随电流的增大,电火花加工陶瓷试样的抗弯强度及其可靠性降低.超声波加工陶瓷试样的表面完整性与磨料粒度有关,随磨料粒度的减小,陶瓷试样的抗弯强度及其可靠性增加.
参考文献
[1] | Jahanmir S;Ramulu M;Koshy P.Machining of ceramics and composites[M].New York: Marcel Dekker Inc,1998 |
[2] | Mishra P K.Non-conventional machining[M].London:Narosa Publishing House,1997 |
[3] | Deng Jianxin;Lee T C .Surface integrity in electro-discharge machining ultrasonic machining and diamond saw cutting of ceramic composites[J].Ceramics International,2000,26:825-830. |
[4] | D. A. Lucca;E. Brinksmeier;G. Goch .Progress in assessing surface and subsurface integrity[J].CIRP Annals,1998(2):669-693. |
[5] | Li Kun;Liao T W .Surface/subsurface damage and the fracture strength of ground ceramics[J].Journal of Materials Processing Technology,1996,57:207-220. |
[6] | Tnshoff H K;Trmpold H .Evaluation of surface layers of machined ceramics[Z].Annals of the CIRP,1989,38:699-708. |
[7] | Petrofes N F;Gadalla A M .Electrical discharge machining of advanced ceramics[J].Ceramic Bulletin,1988,67(06):1048-1052. |
上一张
下一张
上一张
下一张
计量
- 下载量()
- 访问量()
文章评分
- 您的评分:
-
10%
-
20%
-
30%
-
40%
-
50%