以舰船构件为对象,通过玻璃纤维/乙烯基酯树脂复合材料的真空导入成型实验,研究了真空度、树脂温度参数对制件孔隙含量的影响规律.结果表明:真空度大小对孔隙率含量有显著影响,当真空度为80~90kPa时孔隙含量较低;低于20℃时,温度对孔隙含量有明显的影响,温度高于20℃时孔隙含量变化不大;沿树脂流动方向,试件孔隙含量由低到高变化;沿试件从上到下的厚度方向,孔隙含量也呈由低到高增加的趋势.
参考文献
[1] | 祝颖丹,李新华,王继辉,高国强.高渗透介质型真空注射成型工艺的研究[J].复合材料学报,2003(04):136-140. |
[2] | 高彦涛,李炜,罗永康.VARTM工艺中多层玻纤织物渗透规律研究与工艺优化[J].玻璃钢/复合材料,2009(06):54-57. |
[3] | Hongyan Zhu,Baochang Wu,Dihong Li,Dongxing Zhang,Yuyong Chen.Influence of Voids on the Tensile Performance of Carbon/epoxy Fabric Laminates[J].材料科学技术学报(英文版),2011(01):69-73. |
[4] | GHIORSE S R .Effect of void content on the mechanical properties of carbon/epoxy laminates[J].SAMPE Quarterly,1993,24(02):54-59. |
[5] | Ling Liu;Bo-Ming Zhang;Dian-Fu Wang;Zhan-Jun Wu .Effects of cure cycles on void content and mechanical properties of composite laminates[J].Composite structures,2006(3):303-309. |
[6] | 汪赫男,张佐光,顾轶卓,李敏.环氧复合材料层板热压成型孔隙缺陷影响因素[J].复合材料学报,2007(05):55-60. |
[7] | LABORDUS M;PIETERS M;HOEBERGEN A.The causes of voids in laminates made with vacuum injection[A].Puteaux:Society for the Advancement of Meterial and Process Engineering,1999:433-441. |
[8] | MD AFENDI;W. M. BANKS;D. KIRKWOOD .Bubble free resin for infusion process[J].Composites, Part A. Applied science and manufacturing,2005(6):739-746. |
[9] | Hu Jinlian;Liu Yi;Shao Xueming .Study on void formation in multi-layer woven fabrics[J].Composites, Part A. Applied science and manufacturing,2004(5):595-603. |
[10] | 张宝艳,陈祥宝,周正刚.消泡剂对真空压力成型复合材料质量与性能的影响[J].材料工程,2007(12):3-7. |
上一张
下一张
上一张
下一张
计量
- 下载量()
- 访问量()
文章评分
- 您的评分:
-
10%
-
20%
-
30%
-
40%
-
50%