以琼脂糖作为凝胶物质,采用凝胶注模工艺制备了多孔氮化硅陶瓷,通过改变浆料的固相含量,制备了不同性能的多孔氮化硅陶瓷.结果表明,随着浆料的固相含量从35vol％增加到45vol％,材料的气孔率从57.6％减小至40.8％,弯曲强度从96 MPa增加到178 MPa;大量的长棒状β-Si3N4晶粒从孔壁上生长出来,将气孔填充,其生长方式为溶解-沉淀-析出与气-液-固两种生长机制协同作用的结果.长棒状的氮化硅晶须和恰当的界面结合强度是多孔氮化硅陶瓷具有较高强度的主要原因.
参考文献
| [1] | Jian-Feng Yang;Tatsuki Ohji;Shuzo Kanzaki .Microstructure and Mechanical Properties of Silicon Nitride Ceramics with Controlled Porosity[J].Journal of the American Ceramic Society,2002(6):1512-1516. |
| [2] | Mori H.;Yoshimura N.;Hotta T.;Ayama K.;Tsubaki JI.;Mase S. .Fabrication of supported Si3N4 membranes using the pyrolysis of liquid polysilazane precursor[J].Journal of Membrane Science,1998(1):23-33. |
| [3] | Riley F.L.;, .Silicon Nitride and Related Materials[J].Journal of the American Ceramic Society,2000(2):245-265. |
| [4] | Yang J;Yang JF;Shan SY;Gao JQ;Ohji T .Effect of sintering additives on microstructure and mechanical properties of porous silicon nitride ceramics[J].Journal of the American Ceramic Society,2006(12):3843-3845. |
| [5] | Guang-Peng Jiang;Jian-Feng Yang;Ji-Qiang Gao .Porous Silicon Nitride Ceramics Prepared by Extrusion Using Starch as Binder[J].Journal of the American Ceramic Society,2008(11):3510-3516. |
| [6] | Omatcte O O;Janncy M A;Strcllow R A .Gelcasting-a new ceramic forming process[J].American Ceramic Society Bulletin,1991,70(10):1641. |
| [7] | Gilissen R;Erauw J P;Smolders A .Gel-casting-a shape technique[J].Materials & Design,2000,21(04):251. |
| [8] | Janney MA.;Walls CA.;Nunn SD.;Ogle RJ.;Westmoreland G.;Omatete OO. .Development of low-toxicity gelcasting systems[J].Journal of the American Ceramic Society,1998(3):581-591. |
上一张
下一张
上一张
下一张
计量
- 下载量()
- 访问量()
文章评分
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%