参考文献
| [1] | Kelvin L.Contact electricity of metals[J].Philos.Mag.,1898,46:82 |
| [2] | Zisman W.A new method of measuring contact potential differences in metals[J].Rev.Sci.Instr.,1932,3:367 |
| [3] | Baikie I,Venderbosch E,Meyer J,et al.Analysis of stray capacitance in the Kelvin method[J].Rev.Sci.Instr.,1991,62:725 |
| [4] | Parsons R.Equilibrium properties of electrified interfaces[J].Modem Aspects Electrochem.,1954,1:169 |
| [5] | Green M.Solid State Surface Science[M].New York:M.Dekker,1969 |
| [6] | Babai M,Tshemikovski N,Gileadi E.Double layer capacity measurement in dilute solution:a new technique[J].J.Electrochem.Soc.,1972,119:1018 |
| [7] | Besocke K,Berger S.Piezoelectric driven Kelvin probe for contact potential difference studies[J].Rev.Sci.Instr.,1976,47:840 |
| [8] | Baikie I,Petermann U,L(a)gel B.UHV-compatible spectroscopic scanning Kelvin probe for surface analysis[J].Surf.Sci.,1999,433:249 |
| [9] | Nonnenmacher M,Oboyle M,Wickramasinghe H.Kelvin probe force microscopy[J].Appl.Phys.Lett.,1991,58:2921 |
| [10] | Yasutake M,Aoki D,Fujihira M.Surface potential measurements using the Kelvin probe force microscope[J].Thin Solid Films,1996,273:279 |
| [11] | Schmutz P,Frankel G.Characterization of AA2024-T3 by scanning Kelvin probe force microscopy[J].J.Electrochem.Soc.,1998,145:2285 |
| [12] | Bockris J O M,Reddy A K N.Modern electrochemistry[M].New York:Plenum Publishing Corporation,2000 |
| [13] | Bockris J O M,Argade S.Work function of metals and the potential at which they have zero charge in contact with solutions[J].J.Chem.Phys.,1968,49:5133 |
| [14] | Hansen W,Kolb D.The work function of emersed electrodes[J].J.Electroanal.Chem.,1979,100:493 |
| [15] | Stmtmann M.The investigation of the corrosion properties of metals,covered with adsorbed electrolyte layers-A new experimental technique[J].Corros.Sci.,1987,27:869 |
| [16] | J(o)nsson M,Thierry D,Lebozec N.The influence of microstructure on the corrosion behaviour of AZ91D studied by scanning Kelvin probe force microscopy and scanning Kelvin probe[J].Corros.Sci.,2006,48:1193 |
| [17] | Tahara A,Kodama T.Potential distribution measurement in galvanic corrosion of Zn/Fe couple by means of Kelvin probe[J].Corros.Sci.,2000,42:655 |
| [18] | Juzeliūnas E,Sudavi(c)ius A,J(u)ttner K,et al.Study of initial stages of Al-Mg alloy corrosion in water,chloride and Cu (Ⅱ) environment by a scanning Kelvin probe and XPS[J].Electrochem.Commun.,2003,5:154 |
| [19] | Stratmann M,Streckel H,Kim K,et al.On the atmospheric corrosion of metals which are covered with thin electrolyte layers-Ⅲ.The measurement of polarisation curves on metal surfaces which are covered by thin electrolyte layers[J].Corros.Sci.,1990,30:715 |
| [20] | Grundmeier G,Schmidt W,Stratmann M.Corrosion protection by organic coatings:electrochemical mechanism and novel methods of investigation[J].Electrochim.Acta,2000,45:2515 |
| [21] | Doblhofer K,Armstrong R.Membrane-type coatings on electrodes[J].Electrochim.Acta,1988,33:453 |
| [22] | Stratmann M,Streckel H.The Investigation of the corrosion of metal surfaces,covered with thin electrolyte layers--a new experimental technique[J].Ber.Bunsenges.Phys.Chem.,1988,92:1244 |
| [23] | Stratmann M,Leng A,Füürbeth W,et al.The scanning Kelvin probe; a new technique for the in situ analysis of the delamination of organic coatings[J].Prog.Org.Coatings,1996,27:261 |
| [24] | Füürbeth W,Stratmann M.Scanning Kelvinprobe investigations on the delamination of polymeric coatings from metallic surfaces[J].Prog.Org.Coatings,2000,39:23 |
| [25] | de la Fuente D,Chico B,Morcillo M.A SEM/XPS/SKP study on the distribution of chlorides in contaminated rusty steel[J].Corros.Sci.,2006,48:2304 |
| [26] | Nazarov A,Thierry D.Scanning Kelvin probe study of metal/polymer interfaces[J].Electrochim.Acta,2004,49:2955 |
上一张
下一张
上一张
下一张
计量
- 下载量()
- 访问量()
文章评分
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%