通过采用扫描电镜、透射电镜、X射线衍射以及相分析等手段来观察组织的微观结构和对析出相的验证,研究轧制温度对轧态Ti微合金化马氏体钢强度的影响.研究结果表明,通过降低轧制温度可以明显提高含Ti马氏体钢的屈服强度,这主要是因为当轧制温度从1100℃降低到950℃过程中,形变诱导析出大量的TiC析出相,随着轧制温度的降低,析出相数量明显增加,并且平均尺寸也逐渐变小.马氏体中大量存在的1～20 nm范围的析出相可以起到明显的析出强化作用.
参考文献
| [1] | Martin R;Mari D;Schaller R .Influence of the Carbon Content on Dislocation Relaxation in Martensitic Steels[J].Materials Science and Engineering A:Structural Materials Properties Microstructure and Processing,2009,521-522:117. |
| [2] | 李绍宏,邓黎辉,谢殷子,吴晓春.高碳高合金马氏体钢回火过程连续性转变的内耗行为研究[J].钢铁研究学报,2011(04):37-41. |
| [3] | Y.Y. Song;D.H. Ping;F.X. Yin;X.Y. Li;Y.Y. Li .Microstructural evolution and low temperature impact toughness of aFe–13%Cr–4%Ni–Mo martensitic stainless steel[J].Materials Science & Engineering, A. Structural Materials: Properties, Misrostructure and Processing,2010(3):614-618. |
| [4] | 毛新平,孙新军,康永林,林振源.薄板坯连铸连轧Ti微合金化钢的物理冶金学特征[J].金属学报,2006(10):1091-1095. |
| [5] | Guang Xu;Xiaolong Gan;Guojun Ma;Feng Luo;Hang Zou .The development of Ti-alloyed high strength microalloy steel[J].Materials & design,2010(6):2891. |
| [6] | 冯光宏;李岩;戴蓓蓉 等.在未再结晶区大压下后加速冷却工艺对钢板带状组织的影响[J].钢铁研究学报,1999,11(06):14. |
| [7] | 杨才福;张永权;王宇杰 .钛含量对热轧带钢力学性能的影响[J].钢铁,1995,30(08):48. |
| [8] | B.K. Show;R. Veerababu;R. Balamuralikrishnan;G. Malakondaiah .Effect of vanadium and titanium modification on the microstructure and mechanical properties of a microalloyed HSLA steel[J].Materials Science & Engineering, A. Structural Materials: Properties, Misrostructure and Processing,2010(6):1595-1604. |
| [9] | Teber A;Schoenstein F;Tetard F et al.The Effect of Ti Substitution by Zr on the Microstructure and Mechanical Properties of the Cermet Ti1 xZrxC Sintered by SPS[J].International Journal of Refractory Metals and Hard Materials,2012,31:132. |
| [10] | Cao JC;Yong QL;Liu QY;Sun XJ .Precipitation of MC phase and precipitation strengthening in hot rolled Nb-Mo and Nb-Ti steels[J].Journal of Materials Science,2007(24):10080-10084. |
上一张
下一张
上一张
下一张
计量
- 下载量()
- 访问量()
文章评分
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%