欢迎登录材料期刊网

材料期刊网

高级检索

在实验所得结果之基础上研究了预偏角对单搭接胶接接头破坏机制的影响,用弹塑性有限元法模型得到了不同裂纹长度时接头整体和胶层中心等效应力沿裂纹尖端的分布,并研究了外载大小、裂纹长度对应力强度因子的影响.结果表明,同轴接头和标准接头的破坏均从胶层界面开始,但同轴接头以形成较多小裂纹为主,而标准接头中裂纹沿着胶层向中部扩展,最终导致破坏;随裂纹长度的增加,接头上等效应力渐增,胶层中心峰值应力也增大,裂纹尖端的应力远高于其他部位;当裂纹扩展到临界尺寸时,接头会迅速破坏.

The effect of preformed angle on the fracture mechanism of both coaxial joint and off-axial joint paper is studied based on the test results.The effects of crack length in adhesive layer on the equivalent stress distributed in the midbondline and whole joints are investigated using an elastic-plastic finite element analysis (FEA).The effects of the crack length and the value of external load on the stress intensity factor are also studied.The results obtained show that the cracks all originated from the bondline interface in both coaxial and off-axial joint.A lot of small cracks form along the interface of the coaxial joint while the crack develops from the interface toward mid-bondline in the off-axial joint.The equivalent stress in whole joint and the mid-bondline increased when the cracks lengths and external load increase and the stress near the crack tip is much higher than that in the rest zone.The single lap joint fails when the crack length reaches to the critical size.

参考文献

[1] 李智,游敏,丰平.胶接接头界面理论及其表面处理技术研究进展[J].材料导报,2006(10):48-51.
[2] 郭忠信.铝合金结构胶接[M].北京:国防工业出版社,1993
[3] 游敏;郑小玲.连接结构分析[M].武汉:华中科技大学出版社,2004
[4] Li G;Lee-Sullivan P .Finite element and experimental studies on single-lap balanced joints in tension[J].Iht J Adhes Adhes,2001,21:211.
[5] 游敏,严沾谋,郑小玲,余海洲.端部斜削的铝单搭接接头应力分布数值分析[J].航空材料学报,2007(05):91-94.
[6] You M et al.A numerical and experimental study of adhesively bonded aluminum single lap joints with an inner chamfer on the adherends[J].International Journal of Adhesion and Adhesives,2008,28(01):71.
[7] Avila A F;Bueno P O .Stress analysis on a wavy-lap bonded joint for composites[J].International Journal of Adhesion and Adhesives,2004,24:407.
[8] Avila A F et al.An experimental and numerical study on adhesive joints for composites[J].Computers & Structures,2004,7:531.
[9] Min You;Zhi Li;Xiao-ling Zheng .A numerical and experimental study of preformed angle in the lap zone on adhesively bonded steel single lap joint[J].International Journal of Adhesion & Adhesives,2009(3):280-285.
[10] 孙德新,游敏,余珊.同轴单搭接胶接接头力学性能的研究[J].弹性体,2008(01):18-21.
上一张 下一张
上一张 下一张
计量
  • 下载量()
  • 访问量()
文章评分
  • 您的评分:
  • 1
    0%
  • 2
    0%
  • 3
    0%
  • 4
    0%
  • 5
    0%