Pulverized coal injection（PCI） is a key technology in modern ironmaking by blast furnace（BF） and the life of injection lance has a great influence on PCI operation and on normal running of blast furnace.It is found that the main reasons for the failure of the lances are their outer surface oxidation and the inner surface erosion through monitoring some lances used in BF.The outer surface oxidation of the lances made of lCr18Ni9Ti is inevitable under high hot blast temperature condition through thermodynamics analysis.A mathematical model for calculating the temperature of common monocular coal lance had been developed according to the principles of mass and energy balance.Increasing temperature and flow velocity of the hot blast would cause a rise in the lance temperature.The influence of hot blast temperature is more obvious.The lance temperature would decline when compressed air flux increases.Conveying technology of dense phase pulverized coal is beneficial to extending lance’s life because decreasing solid-gas ratio would intensify erosion and burning loss.The anti-oxidation temperature of lance materials needs to be over 1000 ℃ for BF intensified smelting.In order to increase the resistance to oxidation of the coal lance’s outer surface,oxidation-resistant steel or Al coating stainless steel is the appropriate material for BF use.Employing the metal surface treatment technology to enhance the hardness of the coal lance’s internal surface could prolong the service life of coal lance
参考文献
| [1] | Ishii K.Advanced Pulverized Coal Injection Technology and Blast Furnace Operation[M].Oxford:Elsevier Science Ltd,2000 |
| [2] | I. Sengupta;A. Kumar .Blast furnace efficiency enhancer for pulverized coal injection[J].AISE Steel Technology,2000(2):61-62. |
| [3] | Yeh C M;Ho C K;Du S W.The Development of Pulverized Coal Injection Lance With Air Cooling in No.3Blast Furnace[A].Nashville:Ironmaking Division of the Iron and Steel Society,2002 |
| [4] | SU Yun-long;LI Xiao-jing;JIN Jun et al.Research on Construction and Type of Coal Lance for Blast Furnace (in Chinese)[J].Iron & Steel,2008,43(10):13. |
| [5] | WANG Jian-jiang;ZHAO Zhong-min;YE Ming-hui et al.Development and Application of SHS Curved Ceramic-Lined Composite Guns for Coal-Dust-Injection System (in Chinese)[J].Iron & Steel,2000,35(02):12. |
| [6] | CHENG Zheng-dong;WANG Lai-jiu;HAN Qing et al.Development and Application of Shougang High Temperature Alloy PCI Lance (in Chinese)[J].Ironmaking,2000,19(01):24. |
| [7] | HUANG Xi-hu.Principles of Steel Metallurgy(in Chinese)[M].北京:冶金工业出版社,2002 |
| [8] | Briks N;Meier G H;Pettit F S.Introduction to High-Temperature Oxidation of Metals[M].Cambridge:Cambridge University Press,2006 |
| [9] | LI Tie-fan.High Temperature Oxidation and Hot Corrosion of Metals(in Chinese)[M].北京:化学工业出版社,2004 |
| [10] | Finnie I;McFadden D H .On the Velocity Dependence of the Erosion of Ductile Metals by Solid Particles at Low Angles of Incidence[J].Wear,1978,48(01):181. |
| [11] | SHEN Qiao-zhen;DU Jian-ming.Metallurgy Transport Principle(in Chinese)[M].北京:冶金工业出版社,2006 |
- 下载量()
- 访问量()
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%