以X-Y平面依次铺设炭纤维束、Z向穿插炭棒的4D软硬混编为预制体,采用沥青液相常压、高压浸渍/炭化-石墨化循环致密工艺制备4D-C/C复合材料.通过该材料Z向(炭棒方向)的拉伸实验,测定其拉伸性能和力学行为,并采用SEM分析试样表面及断口形貌.结果表明:宏观上拉伸试样以炭棒整体拔出的形式破坏;细观尺度上,试样表面形成了与载荷方向垂直的贯穿性裂纹,裂纹以2mm左右的距离呈等间距分布;材料进一步的破坏过程中,基体裂纹在X-Y向纤维束中呈线性扩展,快速分割了基体材料,使4D-C/C复合材料的拉伸破坏演变为1D-C/C复合材料的破坏模式,由于炭棒与基体炭界面结合弱,炭棒以拔出方式失效和破坏.
参考文献
| [1] | Gajiwala HM.;Sodah SA.;Jeelani S.;Vaidya UK. .Hybridized resin matrix approach applied for development of carbon/carbon composites - I[J].Carbon: An International Journal Sponsored by the American Carbon Society,1998(7/8):903-912. |
| [2] | 苏君明,崔红,苏哲安,郭晨,李瑞珍,李雅娣,周绍建.轴棒法混编4D 炭/炭复合材料喉衬研究[J].炭素,2004(01):12-16. |
| [3] | 王俊山,李仲平,敖明,许正辉,刘朗,胡子君,彭维周.烧蚀过程中C/C复合材料的结构演变[J].新型炭材料,2006(02):103-108. |
| [4] | 刘皓,李克智,李贺军,卢锦花,翟言强.热处理温度对中间相沥青基碳/碳复合材料力学性能的影响[J].材料工程,2007(01):15-18. |
| [5] | 张钧,徐永东,张立同,成来飞,董宁.3D C/SiC复合材料基体裂纹间距分布规律[J].航空材料学报,2003(03):11-14. |
| [6] | Matzinos PD.;Walker A.;Patrick JW. .COAL-TAR PITCH AS A MATRIX PRECURSOR FOR 2-D C/C COMPOSITES[J].Carbon: An International Journal Sponsored by the American Carbon Society,1996(5):639-644. |
| [7] | Marshall D B;Cox B A.Mech.Cyclic behavior of precast posttensioned segmental concrete columns with ECC[J].Material,1988(07):127-133. |
| [8] | 韩红梅,张秀莲,李贺军,岳珠峰,李克智.炭/炭复合材料高温力学行为研究[J].新型炭材料,2003(01):20-24. |
| [9] | 郭领军,李贺军,薛晖,石振海,李克智.短切炭纤维增强沥青基C/C复合材料的组织特征[J].新型炭材料,2004(02):119-123. |
| [10] | Gerlad Camus;Laurent Guillaumat;Stephane Baste .Development of damage in a 2D woven C/SiC composite under mechanical loading:Ⅰ.Mechanical characterization[J].Composites Science and Technology,1996,56(12):1363-1372. |
| [11] | Lara-Curzio E.;Russ CM. .On the matrix cracking stress and the redistribution of internal stresses in brittle-matrix composites[J].Materials Science & Engineering, A. Structural Materials: Properties, Misrostructure and Processing,1998(2):270-278. |
| [12] | 孙乐民,李贺军,张守阳.沥青基炭/炭复合材料的弯曲断裂特征[J].新型炭材料,2001(03):28-31,41. |
| [13] | Paar R.;Danzer R.;Valles JL. .Influence of fibre properties on the mechanical behaviour of unidirectionally-reinforced ceramic matrix composites[J].Materials Science & Engineering, A. Structural Materials: Properties, Misrostructure and Processing,1998(2):209-216. |
| [14] | Hiroshi Hatta;Ken Goto;Shinya Ikegaki et al.Tensile strength and fiber/matrix interfacial properties of 2D-and 3D-carbon/carbon composites[J].Journal of the European Ceramic Society,2005,25(04):535-542. |
| [15] | Hiroshi Hatta;Ken Goto;Takuya Aoki .Strengths of C/C composites under tensile, shear, and compressive loading: Role of interfacial shear strength[J].Composites science and technology,2005(15/16):2550-2562. |
上一张
下一张
上一张
下一张
计量
- 下载量()
- 访问量()
文章评分
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%