通过测定接触角、X射线衍射谱和元素含量，研究预热套管结疤组成和表面性质间的关系。结果表明：随着预热温度升高，结疤相中碱(Na2O)、二氧化硅、氧化铝和磷含量随之升高，氧化镁、二氧化钛、灼减量逐渐减少，氧化钙含量变化不明显；钛酸钙量减少，钠硅渣、水化石榴石量增多，且水化石榴石中二氧化硅系数增大，结疤的硬度增强；由于钠硅渣、水化石榴石、赤铁矿比钛酸钙的亲水性强，随着温度的升高，套管结疤的亲水性增强，疏水性减弱，因而，高温下更有利于生成更致密、难清理的结疤。加入有机添加剂，可以改变渣相的表面性质，为防止结疤提供新途径。
In order to inhibit scale’s formation, the relationship between composition of scale and its surface property was investigated by the analysis of contact angle, X-ray diffraction and elemental content of scale.The results show that, with the increase of preheating temperature, the contentsof alkali soda, silica, alumina and phosphorus increase,but thoseof magnesia, titania and igloss reduces gradually, the content of calcium oxides almostremains unchangeable. Increasing temperature raises the content of sodium hydrate alumino-silicate and hydrogarnet,but reduces the content of calcium titanate in scale. Moreover, increasingpreheating temperature not only increasesthestoichiometric coefficient of SiO2in hydrogarnet,butalso improves the Moh’s hardness of the scale.Becausethe hydrophilicitiesofsodium hydrate alumino-silicate, hydrogarnet and hematitearegreater than that of calcium titanate,increasing temperature enhances scale’shydrophilicity and declinesscale`shydrophobicity.Therefore,the elevated temperature is conducive to the formation of the compact scale due to the hydrophilicity ofsodium hydrate alumino-silicate and hydrogarnet, leading to difficult removal of the scale.In addition,the surface properties of the scale can be changed by adding the organic additive, implying an available method to inhibit the formation of the scale.
参考文献
| [1] | K. Dudek;F. Jones;T. Radomirovic.The effect of anatase, rutile and sodium titanate on the dissolution of boehmite and gibbsite at 90 deg C[J].International Journal of Mineral Processing,20092(2):135-140. |
| [2] | Xiaobin Li;Qiusheng Zhou;Haoyu Wang;Zhihong Peng;Guihua Liu.Hydrothermal formation and conversion of calcium titanate species in the system Na_2O–Al_2O_3–CaO–TiO_2–H_2O[J].Hydrometallurgy,20102(2):156-161. |
| [3] | 尹中林;顾松青.石灰添加方式对一水硬铝石型铝土矿浆预热过程结疤的影响[J].中国有色金属学报,2001(5):910-914. |
| [4] | 尹中林;顾松青;毕诗文.双流法预热条件下铝土矿浆中杂质矿物的反应行为[J].中国有色金属学报,2005(2):310-315. |
| [5] | 尹中林;毕诗文;顾松青.铝土矿中含钛矿物在矿浆预热过程中反应动力学研究[J].矿冶工程,2005(4):54-57. |
| [6] | 袁华俊;黄芳;李琴琴;项阳;袁艺.高压溶出过程结疤的分类及危害[J].贵州工业大学学报(自然科学版),2002(5):16-21. |
| [7] | 黄芳;袁华俊;赵飞;王家伟.平果铝高压溶出预热过程结疤性质研究[J].贵州工业大学学报(自然科学版),2001(5):18-22. |
| [8] | 袁艺;黄芳;刘华龙;刘世荣;马海珠.高压溶出硅质结疤物的形态结构研究[J].矿物学报,2014(3):421-426. |
| [9] | 周萍;李旺兴;周孑民;吕子剑;闫红杰;孙剑峰.管道化溶出生产过程中熔盐加热段结疤与传热规律的研究[J].轻金属,2001(7):20-22. |
| [10] | J. Wu;G. Lane;I. Livk.Swirl flow agitation for scale suppression[J].International Journal of Mineral Processing,2012:19-29. |
| [11] | S.J. Nawrath;M.M.K. Khan;M.C. Welsh.An experimental study of scale growth rate and flow velocity of a super-saturated caustic- aluminate solution[J].International Journal of Mineral Processing,20062/4(2/4):116-125. |
| [12] | 陈保华;赵晓峰.常用硬度的测试原理及表示方法[J].金属加工（热加工）,2008(15):69-71. |
| [13] | 刘桂华;齐天贵;田侣;周秋生;彭志宏;李小斌.氧化镁在铝酸钠溶液脱硅中的反应行为[J].中国有色金属学报,2013(7):2055-2060. |
| [14] | 李小斌;徐华军;刘桂华;彭志宏;周秋生;刘云峰.氧化铝熟料溶出过程中SiO2的行为[J].过程工程学报,2006(3):431-434. |
| [15] | Kwok DY.;Neumann AW..Contact angle measurement and contact angle interpretation [Review][J].Advances in Colloid and Interface Science,19993(3):167-249. |
| [16] | 谢巧玲;陈文汨.铝酸钠溶液中S2-对低合金钢腐蚀行为的影响[J].中国有色金属学报,2013(12):3462-3469. |
| [17] | 李小斌;赵东峰;章宣;刘桂华;彭志宏;周秋生.赤泥主要物相的表面性质对其沉降性能的影响[J].中国有色金属学报,2012(1):281-286. |
- 下载量()
- 访问量()
- 您的评分：
-
10%
-
20%
-
30%
-
40%
-
50%