材料期刊网

用水合肼还原硝酸铜溶液的方法，合成出高长径比的单晶铜纳米线，用X射线粉末衍射仪、扫描电镜、透射电镜等对产物进行了分析，研究了原料配比、水合肼加料方式等工艺因素对反应产物的影响；用孔径为0．45μm的注射式过滤膜滤出铜线并接触转移到透明商用手机贴膜表面制成铜纳米线膜，用紫外一可见光谱仪和四探针表面电阻仪分别测试其可见光透射率和表面电阻。结果表明：80℃时，制备的铜纳米线长度大于40μm，直径小于100nm；铜纳米线膜的可见光透射率为50％，平均方块电阻为26Ω。

The copper nanowires with high aspect ratio were prepared by chemical reduced Cu(NO3 )2 solution with hydrazine hydrate. It was characterized through X-ray diffraction, scanning electron microscopy, transmission electron microscopy. The effect of reaction conditions on the product, such as the ratio of raw materials, the feeding mode of hydrazine hydrate, was investigated. The copper nanowires was filtered out by the syringe filter membrane with 0. 45 ~m pore diameter, and was transfered to a commercial optical film of mobile telephone to prepare the copper nanowires film. The luminousness and surface resistance of copper nanowires were measured by the ultraviolet spectrograph and the 4-points probe sheet resistance instrument. Results show that the obtained copper nanowires were single crystal with the length greater than 40μ m and the diameter less than 100 nrru The obtained conducting copper nanowire film shows 50% visiable light transmittance and the average surface resistance was 26Ω.